Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/Power tools and appliances
Industry solution

Screw driving for power tool and motor assembly

Motor-driven products are assembled to a torque specification that the end customer can feel. Consistency is the product feature, and consistency is what a machine sells.

At a glanceTypical fastening: M2.5 – M4.0 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

Power tools, pumps and small motors are built with M2.5 to M4.0 screws holding housings, end caps, stators and terminal blocks. The joints carry real loads — vibration, thermal cycling and, on tools, shock — so the specification is a defined torque rather than "tight enough". A tool that leaves the factory with one loose housing screw is a warranty return regardless of how well the rest of the unit was built.

Product families also tend to be wide and volumes moderate, which changes the economics. A machine that needs half a day of retooling between models will not be used. The practical requirement is fast changeover: stored programs per model, fixtures that locate from features shared across the family, and screw feed that can be switched without dismantling the deck.

Where the joint runs into a stator or a laminated stack, force control matters more than torque resolution. The stack does not tolerate a screw driven to a hard stop, so seating is detected by displacement and the drive releases as soon as the joint closes.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Model family and changeover

List the models to be built on the station and how often they change. Changeover time, not cycle time, is usually the deciding factor.

Torque specification

Confirm the specified torque and tolerance for each joint, and whether the customer wants to see the record.

Fragile stack-ups

Stators, laminations and potted assemblies need displacement-based seating detection rather than a torque stop.

Shared fixture features

Design fixtures to locate from features common across the model family so one fixture covers several models.

Operator skill level

Stored programs mean the operator selects a model rather than setting up a machine — worth stating explicitly if your line has high staff turnover.

Common questions

Frequently asked questions

How long does it take to change over between models?
It depends on how much of the fixture is shared. With stored programs and a family fixture, changing model is a program selection plus a feeder change. If each model needs its own fixture, changeover is a physical swap — we will tell you which you are buying before you order.
Can the machine torque to a specification rather than to a feel?
Yes. Torque and angle targets are set per joint in the program and monitored during tightening, so the result is repeatable rather than operator-dependent.
Will it damage laminated stacks or stators?
We drive those joints with force control and displacement-based seating detection, so the machine stops when the joint closes instead of continuing to push.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.