Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Guides/Choosing a screw driving machine
Technical guide

How to choose an automatic screw driving machine

Six questions decide most screw-driving machine purchases. Answer them in order and the specification writes itself.

At a glanceScrew range and feed M1.7–M5.0 on our platforms; vacuum pick-up below about M2.0, mechanical feed for volume. · Torque window Wide window: single-stage torque stop. Narrow window: two-stage tightening with monitored final stage.

Most engineers arriving here go straight to one of these:

Technical guide

Start with the screw, not the machine. The thread size, head form and drive recess decide how the screw can be presented — vacuum pick-up for small heads and low volumes, a mechanical feeder once a single screw type runs in real volume. Our platforms cover M1.7 to M5.0, and the practical limit on a given station is usually the feed arrangement rather than the driver.

Then define the torque window and decide how tight it actually is. A wide window on a robust joint tolerates a simple torque stop. A narrow window on a joint that closes within a few degrees of rotation needs two-stage tightening with the final stage monitored, and a driver whose minimum settable torque sits below the target. Getting this wrong produces a machine that technically drives screws and practically fails inspection.

After that come the three questions buyers most often leave too late. How will the part be held — where can it be supported from below, and can the fixture prevent wrong-orientation loading? What is the real cycle time — the drivers run 0.37–0.41 s per screw, but travel between screws normally dominates, so count positions and distance rather than screws alone. And does anything need to be recorded — if a tightening record per unit is required, agree the data format and the interface before the machine is built, because it is a software configuration rather than a rebuild later.

Last updated 2026-11-20. Screw range, torque and cycle-time figures reflect the current published platform specifications.

What to specify

Key points to take away

The practical conclusions from the sections above.

Screw range and feed

M1.7–M5.0 on our platforms; vacuum pick-up below about M2.0, mechanical feed for volume.

Torque window

Wide window: single-stage torque stop. Narrow window: two-stage tightening with monitored final stage.

Fixture and support

Support under every screw position is ideal, under the corners is the minimum. Design in wrong-orientation prevention.

Real cycle time

Count screw positions and travel distance, not just screws. Driving is 0.37–0.41 s per screw; travel is usually the larger term.

Traceability

Decide the record format and interface before the machine is configured — it is a setting, not a rebuild.

Working area

Our platforms lock over 500 × 400 × 100 mm. Larger parts need a moving table or multiple stations.

Common questions

Frequently asked questions

What is the most common mistake when buying a screw driving machine?
Under-specifying the fixture. Most applications that fail do so because the part moves or deflects during driving, not because the machine could not drive the screw accurately.
How do I calculate the cycle time I can expect?
Multiply screw count by 0.37–0.41 s, then add travel time between positions based on the distances and the axis speed. Travel is usually the larger of the two, which is why the screw count alone is a misleading figure.
Should I buy a Cartesian gantry or a robot arm?
A gantry is cheaper, stiffer and simpler where all screws can be approached from above. An arm is needed when the joint is on another face or behind an obstruction, or when cycle time demands simultaneous motion.
Keep reading

Related pages

Not sure which applies to you?

Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.