Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/LED lighting
Industry solution

Screw driving for LED lighting assembly

Luminaire assembly is high-volume, low-margin and heavily visual. The machine has to be fast and it has to not mark the product.

At a glanceTypical fastening: M3.0 – M4.0 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

An LED luminaire is assembled from a heat sink, an LED board, a driver and a diffuser or lens, held with M3.0 to M4.0 screws. Screw counts are moderate but volumes are large, and the margin on a luminaire does not tolerate scrap. The heat sink is often aluminium with a painted or anodised finish, so tooling that scuffs the visible surface is a scrap cause independent of the joint itself.

Screw length variation is the specific hazard. Panels, battens and downlights frequently use the same thread in two or three lengths, and a too-long screw driven into a driver cavity or through a PCB is a functional failure that a visual inspection will not catch. Automated feed with one screw type per feeder removes that class of error entirely.

For linear products the joints are spread over a long part, which is where a Cartesian gantry is at its best — the working area on our platforms is 500 × 400 × 100 mm per station, and long parts are run in stations or on a moving table. For compact downlights, a single-station bench machine with a rotary index is usually the cheaper answer.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Screw lengths in the range

List every length used. One screw per feeder is the rule; mixing lengths in one feeder is the mistake automation is meant to eliminate.

Visible surface handling

Specify which faces must not be marked so the fixture and any contact tooling can be designed around them.

Part length and layout

Long linear parts push the machine towards a gantry with a moving table or multiple stations rather than one head travelling.

Heat sink material

Aluminium heat sinks dissipate heat away from the joint; the fixture must hold the assembly thermally as well as mechanically during high volume running.

Driver and PCB clearance

Confirm board thickness and driver cavity depth so screw length can be verified against the maximum permitted engagement.

Common questions

Frequently asked questions

Can one machine handle several luminaire lengths?
Yes. Programs are stored per product and the fixture is designed around the family. For very long linear products we usually recommend a gantry with a moving table so the part is presented rather than the head travelling the whole length.
How do you avoid marking anodised heat sinks?
Contact is limited to designed support points with soft tooling, and downward force is controlled by the displacement sensor rather than by operator pressure.
Does the machine check the screw actually went in?
Yes. Missed-screw detection is standard: the machine verifies engagement and automatically re-tightens where a screw has not seated, then alarms if it still fails.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.