Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology

One production line, one supplier

Your line is not one machine. It is a sequence of stations, and the station you are missing decides your output. Below is that sequence as we build it: 10 stations covered by 39 machine models from our own factory, and the remaining stations sourced to your print and your cycle time.

Process map

The four stages we build around

Ordered the way a real line runs — not the way a catalogue is usually sorted. Where a station is ours you get our machine; where it is not, we still quote it, because a line with one missing station does not ship.

01

Board level

What happens to the bare board before it becomes an assembly.

02

Through-hole

Insertion, wave soldering and lead finishing for through-hole parts.

03

Assembly

Fastening, gluing and soldering the finished assembly — our core.

04

Finish & trace

Marking, labelling and checking before the unit is packed.

  • Vision inspectionSourced to your spec
  • Laser markingSourced to your spec
  • Labeling1 model
Honest split

10 stations in our own build, 5 sourced

We would rather tell you which is which up front than have you find out during commissioning. The stations marked “sourced” in the process map above are quoted against your part and your takt time, with the same single point of contact as the machines we build ourselves.

Built in our own factory

IC programming, tape & reel, lead cutting, board cleaning, screw driving, robotic cells, dispensing, soldering, magnet assembly and labeling — 39 models across 10 stations, configured to your part before it ships.

See the models →

Sourced to your specification

depaneling, component insertion, wave soldering, vision inspection and laser marking. We take the specification, quote it, and stay the single point of contact through installation — you do not manage three suppliers to finish one line.

Ask about a station →

How a turnkey order runs

From part drawing to line acceptance

1. Process flow

You send the part, the takt time and the stations you already have. We map the gaps rather than selling you what we happen to stock.

2. Fixture & cycle

Each station is quoted with its fixture, cycle time and operator count, so the line total is a number you can check, not a range you have to trust.

3. Build & FAT

Machines are run on your parts before shipment and the torque, shot size or soldering profile is recorded against the acceptance sheet.

4. Install & spares

Installation, operator training and a wear-parts list per station, so a stopped line is a phone call rather than an import order.