Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/Electrical panels
Industry solution

Screw driving for electrical panel and switchgear assembly

In a panel, a screw is an electrical connection. Torque is a safety specification, and the record of it is what an inspector asks for.

At a glanceTypical fastening: M3.0 – M5.0 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

Panel and switchgear assembly uses M3.0 to M5.0 machine screws for terminal blocks, busbars, cable lugs, DIN rail components and door hardware. The current-carrying joints are the ones that matter: a terminal tightened below its specified torque runs hot under load, and the failure appears months later as heat damage rather than as a loose screw. Torque here is a safety parameter, not a quality preference.

Panel layout makes the work physically awkward. Joints sit at the back of a shallow enclosure, behind wiring, and on more than one face. That is a reach and orientation problem, and it is the reason panel work is one of the last assemblies to be automated: a gantry has to reach inside the box and a hand has the advantage of being small and flexible.

The configurations that work are usually either a gantry over a fixture that presents one face of the panel at a time, or a six-axis arm that can approach from the angle the joint requires. Either way, torque-controlled driving with a record per terminal is what turns the station into something an inspector can accept, and it is often the deciding benefit rather than the labour saving.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Torque specification per terminal

Current-carrying joints have a defined torque, frequently marked on the component. The machine is programmed per terminal rather than to a single global value.

Reach and approach angle

Count the joints that cannot be reached from vertically above — those decide whether a gantry is sufficient or an arm is needed.

Fixture strategy

Deciding how many faces of the panel the fixture presents, and how the panel is held without distorting the enclosure.

Record per terminal

A per-joint torque record is usually the compliance argument, and it is a software feature rather than extra hardware.

Wiring already installed

If wiring is fitted before the panel is screwed, the handling plan changes — agree the assembly sequence with us.

Common questions

Frequently asked questions

Can the machine torque terminals to a certified value?
Yes — torque and angle targets are set per joint in the program and monitored during tightening, with the result recorded for each terminal.
How do you reach joints inside a shallow enclosure?
Either an indexed fixture that presents one face at a time to a gantry head, or a six-axis arm if the approach angles are awkward. Send us the panel drawing and joint list and we will say which applies.
Is this worth automating for low panel volumes?
Not for the labour alone. The decisive factor is when per-terminal torque records are required for compliance, because that is the part manual assembly cannot produce.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.