Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/Camera and optical modules
Industry solution

Screw driving for camera and optical module assembly

When the alignment of a lens matters more than the strength of the joint, the machine is really a metrology tool with a screwdriver on the end.

At a glanceTypical fastening: M1.7 – M2.3 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

Camera modules, sensor packages and optical assemblies use M1.7 to M2.3 screws, sometimes only two or three per unit. The screws do not carry much load, but they set the geometry: tightening one corner more than another tilts a sensor plane, and a tilt that is invisible to the eye is a failed module at the test station. Consistency across the screws on a unit matters more than the absolute torque value.

Torque for these joints is low and the usable window is small, so the driver needs resolution rather than power. Driving speed also has to be reduced because the joint closes within a few degrees of rotation; a driver that runs at full speed into a low-torque target will overshoot it. Our smart drivers allow both the speed profile and the target to be set per screw, which is what makes this class of joint automatable at all.

Because the modules are delicate and often mounted in carriers, the fixture does most of the work. It has to hold the module without distorting the carrier, present the screws at a consistent angle, and allow the unit to be removed without being disturbed. Where flatness is specified, the fixture is normally designed so the module is supported across its whole lower face rather than at points.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Torque resolution

Low-torque joints need a driver whose minimum settable torque is well below the target, not one whose maximum is impressive.

Speed profile

Run-down and final tightening are separate stages, so the tool does not overshoot the window on a joint that closes in a few degrees.

Tilt and flatness

If the joint affects alignment, agree the sequence across the screws — crossing from corner to corner rather than working around the pattern.

Full-face support

For flatness-critical modules, support the whole lower face in the fixture rather than locating at points.

Handling after driving

Plan how the assembled module leaves the fixture without being disturbed; this is frequently where a good join is undone.

Common questions

Frequently asked questions

Can the machine handle very low torque targets?
Yes. The limitation to check is driver resolution at the low end, not maximum torque — for these joints we specify a tool whose usable range sits around the target rather than above it.
How do you stop the joint being over-driven?
By driving in two stages with a reduced speed for final tightening, and by stopping on a monitored torque and angle rather than on a time or a travel.
Will the fixture move the module during tightening?
That is a fixture design question and it is where most of the engineering goes on optical assemblies. Full-face support and controlled clamping keep the module still while screws are driven in sequence.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.