Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/Home appliance
Industry solution

Automatic screw driving for home appliance assembly

Appliance assembly combines the two things that break manual driving at scale: a large number of screws per unit, and several different screws on the same unit.

At a glanceTypical fastening: M3.0 – M5.0 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

A domestic appliance is usually held together with between twenty and sixty screws, ranging from M3.0 self-tapping screws into sheet metal to M5.0 machine screws clamping structural brackets. Two problems follow from that. The first is sheer repetition: at appliance line rates the operator is driving a screw every few seconds for a whole shift, and the fatigue signature shows up as under-torqued screws in the last hours of the shift. The second is fastener confusion — when four similar-looking screws are in the same bin, the wrong one gets used, and it is only discovered at repair, not at assembly.

Deep or obstructed joints are the other recurring issue. Screws at the back of a cabinet or inside a drum assembly are reached with an extension, and every extension adds angular error. A Cartesian gantry with a long Z stroke holds the angle far better than a hand with an extension bar, and a six-axis arm reaches positions a gantry physically cannot.

Because appliances are tested after assembly, automation also changes what gets tested. Instead of a leak or function test catching a loose fastener, the tightening data shows it at the station. Combined with missed-screw detection and automatic re-tightening, the station reports its own quality rather than leaving it to be discovered downstream.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Fastener count and mix

List every screw on the unit with its size and position. This decides how many spindles or whether a single head travels.

Multi-spindle or single head

If several screws are on the same plane, multiple spindles drive them simultaneously and cut cycle time roughly proportionally.

Reach and orientation

Screws on more than one face of the cabinet force a choice between repositioning the part and using an articulated arm.

Torque per joint

Sheet-metal self-tapping and machine screws need different torque programs. Both are stored on the machine and selected per position.

Quality record

Decide up front whether tightening data goes to your MES or stays on the machine as a local log.

Common questions

Frequently asked questions

How many screws per unit can the machine handle?
There is no fixed limit — the constraint is the number of screw positions you can present in one fixture and the cycle time you need. Multi-spindle configurations drive several same-plane screws at once.
Can one machine drive both M3.0 self-tapping and M5.0 machine screws?
Yes, with separate programs and separate feed paths. Where the two screw types are used in similar volumes we normally fit two feeders and select per position.
What happens if the wrong screw is loaded into the feeder?
The feeder is sized to one screw, so a wrong screw either will not singulate or will be caught by head-geometry checks. This is one of the quieter benefits of automation — the machine cannot reach into the wrong bin.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.