Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Solutions/Automotive parts
Industry solution

Screw driving for automotive part assembly

In automotive supply, the screw is rarely the deliverable — the record of the screw is. The machine is bought for traceability as much as for speed.

At a glanceTypical fastening: M3.0 – M5.0 · single- and dual-platform screw driving and dispensing cells configured per part · built in Dongguan, China since 2011

Most engineers arriving here go straight to one of these:

Industry solution

Automotive components reach the car maker with a documented tightening process. Brackets, lamp assemblies, sensors, actuators and interior modules are assembled with M3.0 to M5.0 screws, and the tier-one or tier-two supplier is expected to show that each joint was tightened to specification. A torque wrench and a paper log does not survive an audit; a machine that logs torque, angle and result per screw per unit does.

The joints themselves are mechanically harder than they look. Many are metal-on-metal or metal-into-thermoplastic, where torque develops very quickly in the last few degrees. Driving fast and stopping on torque overshoots; driving slowly and stopping on torque makes the cycle time unacceptable. The usual answer is a two-stage strategy — fast run-down, controlled final tightening — which is a driver capability rather than a machine-size question.

There is also a handling dimension. Automotive parts are frequently orientation-critical and sometimes asymmetric, so the fixture has to prevent loading the part the wrong way round rather than relying on the operator to notice. Poka-yoke in the fixture is cheap; a scrapped painted bumper is not.

What to specify

What decides the machine for this application

These are the parameters we need from you to configure a station rather than to guess at one.

Traceability format

Establish what the customer wants to receive — per-joint torque and angle, pass/fail, timestamps — and by what interface, before the machine is configured.

Tightening strategy

Two-stage (fast run-down then controlled final torque) is usually required where the joint stiffens suddenly.

Fixture poka-yoke

Design the fixture so a wrongly oriented part cannot be loaded, instead of relying on operator attention.

Paint and finish handling

Visible parts need tooling that will not mark the surface — soft jaws and controlled contact force.

Cycle time versus PPAP

Confirm the target cycle time is achievable with the required tightening strategy; the two constrain each other.

Common questions

Frequently asked questions

Can the machine produce the tightening records required for PPAP?
The machine records torque, angle, sequence and pass/fail for every screw on every unit, and can upload that to your MES or export it. You should confirm the exact format your customer requires before we configure the data interface.
Does it support torque-and-angle tightening, not just torque?
Yes. The smart drivers support two-stage tightening with a monitored final stage, which is what most automotive joints need.
How do you prevent the operator loading the part the wrong way?
The fixture is designed so the part only physically fits in the correct orientation. This is standard practice for us on parts where a wrong load means a scrapped finished surface.
Keep reading

Related pages

Tell us about your joint

Send the part, the screw size and the torque window and we will come back with a configuration and a cycle-time estimate.