Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Guides/Vision-guided screw driving
Technical guide

Vision-guided screw driving: when it is worth it

Vision solves one problem well: the part is not in exactly the same place every cycle. If it is, vision is an expensive way to fix something else.

At a glancePositional variance Measure the actual spread of screw hole positions in production. If it is comparable to the thread clearance, vision is justified. · Mixed models Vision can identify the variant and select the program, removing a real operator error source.

Most engineers arriving here go straight to one of these:

Technical guide

The core case for vision is positional variance. If parts arrive from a moulding machine, a manual load or a conveyor without precise location, their screw holes may sit a millimetre or two away from nominal. A machine driving to fixed coordinates will miss; a vision system finds the holes and corrects the coordinates per part. That is a genuine capability, and it is worth paying for when the variance exists.

The second case is mixed models. Where several similar products run down the same line, vision can identify which variant has been loaded and select the correct program automatically, which removes a common operator error and shortens changeover. Our CCD-equipped models additionally support automatic program generation — teaching a new part from the vision image rather than by driving every position by hand.

Where vision does not help is when the part is well located and the failure is elsewhere. Vision will not fix a fixture that flexes under driving force, a torque window that is too narrow for the driver, or a screw that cross-threads because the bit starts rotating before it is seated. Those are mechanical and control problems, and adding a camera to a station that has them produces a precise measurement of the wrong thing. Establish which category your problem is in before specifying vision.

Last updated 2026-11-20. Screw range, torque and cycle-time figures reflect the current published platform specifications.

What to specify

Key points to take away

The practical conclusions from the sections above.

Positional variance

Measure the actual spread of screw hole positions in production. If it is comparable to the thread clearance, vision is justified.

Mixed models

Vision can identify the variant and select the program, removing a real operator error source.

Teaching effort

CCD models support automatic program generation from the vision image, which shortens new-part introduction.

Not a fixture substitute

Vision corrects where the hole is; it does not stop the part moving while the screw is driven.

Lighting stability

Vision performance depends on lighting. Where ambient light varies, the station needs its own controlled illumination.

Common questions

Frequently asked questions

Do I need vision if my fixture is accurate?
Usually not. If the part is consistently located and the holes do not vary more than the thread clearance allows, driving to fixed coordinates is faster, simpler and cheaper.
Can vision teach a new part automatically?
On our CCD-equipped models, yes — the part is taught from the vision image rather than by driving every position manually, which shortens changeover for new variants.
Will vision fix my cross-threading problem?
Only if the cause is hole position error. If the part moves during driving or the bit rotates before it is seated, the fix is in the fixture or the driver control, not in the camera.
Keep reading

Related pages

Not sure which applies to you?

Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.