Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Guides/MES integration
Technical guide

Getting tightening data into your MES

The interface is a small amount of work if it is specified before the machine is built, and a project if it is specified afterwards.

At a glanceFields per screw Target torque, achieved torque, angle, pass/fail, timestamp, program identity and screw position. · Unit identity Scanned at a standalone machine, or taken automatically from line control where the station is in line.

Most engineers arriving here go straight to one of these:

Technical guide

A screw-driving station that reports to an MES is doing two things: it drives the screws, and it produces a stream of measurements. The measurements are per screw — target torque, achieved torque, angle, result, timestamp — and they need three pieces of context to be useful: which unit they belong to, which program was running, and which position on the unit the screw occupies.

The unit identity is the part of the interface that customers most often leave unspecified. If the machine is standalone, the operator scans or enters a serial number and the record is grouped under it. If the machine is in line, the identity should come from the line control system automatically, because asking a human to type a serial number at machine speed is how records end up attached to the wrong unit. Agree which of the two applies before configuration.

On the machine side, our platforms publish over Ethernet or Wi-Fi and hold the records as tamper-proof entries, so the same data can serve both the plant's quality system and the customer's acceptance requirement without a second measurement. Practically, the specification exercise is short and worth doing early: list the fields your MES needs, say how the unit identity arrives, and confirm whether the machine must also be able to reject a unit and signal the line to divert it.

Last updated 2026-11-20. Screw range, torque and cycle-time figures reflect the current published platform specifications.

What to specify

Key points to take away

The practical conclusions from the sections above.

Fields per screw

Target torque, achieved torque, angle, pass/fail, timestamp, program identity and screw position.

Unit identity

Scanned at a standalone machine, or taken automatically from line control where the station is in line.

Transport

Ethernet or Wi-Fi from the machine; agree the protocol with your MES team early.

Tamper-proof storage

Records captured at the driver with no editing path, so they can be used as acceptance evidence.

Reject signalling

Decide whether a failed unit must trigger a line diverter or simply raise an alarm at the station.

Local fallback

Agree what happens when the network is down — buffering on the machine is usually the requirement.

Common questions

Frequently asked questions

What data does the machine actually send?
Per screw: target and achieved torque, angle, pass/fail and timestamp, together with the program identity and the screw position, grouped under the unit identity.
Can the machine work without an MES?
Yes. It can run standalone and hold a local log that you export on demand. MES integration adds automatic attachment of records to unit records; it is not required for the machine to operate.
How much work is MES integration?
The machine-side work is a configuration rather than a development project, provided the field list, the unit-identity method and the transport are agreed before the machine is built.
Keep reading

Related pages

Not sure which applies to you?

Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.