Mexico is the easiest of the three North American markets for us electrically — 220 V 60 Hz is a common supply and the build difference is small.
At a glanceBuild: 127 / 220 V, 60 Hz · Conformity: NOM for applicable goods · Region: North America
Most engineers arriving here go straight to one of these:
Mexican industrial supply is 60 Hz, and 220 V single phase is widely available alongside 127 V. That makes the electrical adaptation simpler than for a US or Canadian 208 V site: the machine stays on a 220 V nominal supply and only the frequency setting changes. As always, we ask for the measured supply at the intended machine position rather than the nominal figure.
For goods entering Mexico, NOM certification applies to a range of electrical products, and whether a particular machine requires it depends on its classification and on what the importer declares. Rather than assert an answer that may not apply to your case, we will tell you what documentation we can supply and you should confirm the requirement with your customs broker before shipment — that is the party whose reading matters at the border.
The commercial case for Mexico is proximity to US customers under existing manufacturing arrangements, and a growing appliance and automotive component base. Machines ship to Manzanillo or Veracruz on a regular schedule, or overland if your logistics provider consolidates. Pre-programming before shipment and remote commissioning apply here as elsewhere.
Market-specific details that change the build, the paperwork or the logistics — settle these at enquiry stage.
220 V single phase at 60 Hz is the easiest match; confirm what is actually available where the machine will stand.
Confirm with your customs broker whether your classification requires NOM. We supply the technical documentation we hold.
Agree the commercial invoice, packing list and certificate of origin content with your broker before the machine ships.
Manzanillo and Veracruz are the usual arrival points; decide who handles the inland leg and clearance.
Ask about spares shipped from stock so a wear part does not wait for the next consolidated container.
Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.