Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Guides/Automatic vs manual cost
Technical guide

Automatic vs manual screw driving: comparing the real cost

The labour saving is usually the smallest number in the comparison. The larger ones are rework, scrap and inspection — and they are the ones buyers forget to count.

At a glanceDirect labour Real but usually not decisive on its own at mid volume. · Rework and scrap Count the accumulated value destroyed by a single failed joint, not the cost of the screw.

Most engineers arriving here go straight to one of these:

Technical guide

Start with the direct labour, because it is the number everyone reaches for first, and then deliberately put it aside. Saving one operator's time on a screw-driving station is real, but on a mid-volume line it is rarely enough on its own to justify a machine. The comparison becomes interesting when you add the costs that sit behind the operator.

Rework and scrap are usually the larger terms. A cross-threaded screw in a finished sub-assembly destroys the sub-assembly, not the screw, and the cost is the accumulated value of everything already built into it. Hand-cracked plastic bosses and over-driven joints into soft materials are the same story. These costs are rarely recorded per station, which is exactly why they go uncounted — but if your inspection station reports the same defect repeatedly, that repetition is the number to quantify.

Then add inspection and traceability. If a human has to sample-check torque, or if a customer requires a tightening record per unit, manual assembly cannot produce it at all. Where a record is required, the machine is not competing against labour cost — it is the only option that satisfies the requirement, and the honest advice is that this class of project should be justified on compliance rather than on labour saving. Conversely, if your volumes are low, the joints are robust, the torque window is wide and nobody needs a record, manual driving is genuinely cheaper and we will say so.

Last updated 2026-11-20. Screw range, torque and cycle-time figures reflect the current published platform specifications.

What to specify

Key points to take away

The practical conclusions from the sections above.

Direct labour

Real but usually not decisive on its own at mid volume.

Rework and scrap

Count the accumulated value destroyed by a single failed joint, not the cost of the screw.

Inspection cost

Torque sampling is a recurring labour cost; automation verifies every joint as a by-product.

Traceability requirement

If a per-unit record is mandatory, manual assembly cannot satisfy it at any labour rate.

Changeover cost

High-mix production adds setup time for both options — check which one absorbs it better.

When not to automate

Low volume, robust joints, wide torque window and no record requirement is a legitimate reason to stay manual.

Common questions

Frequently asked questions

Can you predict the savings for my plant?
No — and any supplier who gives you a single figure is guessing. It depends on your rework and scrap rate and on your volume. Build the comparison from your own joint count, takt rate and defect report and we will work through it with you.
Is automation worth it for low volumes?
Usually not on labour alone. It becomes worth it when a torque record is required, or when the joint is fragile enough that manual driving produces regular scrap.
What costs do buyers most often forget?
Scrapped sub-assemblies — the value already built into a part destroyed by one bad joint — and the recurring labour of torque sampling inspection.
Keep reading

Related pages

Not sure which applies to you?

Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.