Automatic screw driving & non-standard automation equipment — Manufacturer since 2011
CB CBZINChengbo Intelligent Technology
Home/Guides/Torque and traceability
Technical guide

Screw torque and traceability: what to record and why

A tightening record is not a log of what the machine did. It is evidence that a joint was made to specification — and the distinction decides the format.

At a glanceTorque and angle together The pair distinguishes a bottomed-out screw from a stripping thread; torque alone cannot. · Tamper-proof storage Records that can be edited are not evidence. Machine-side capture removes the editing path.

Most engineers arriving here go straight to one of these:

Technical guide

Two values matter at every joint: torque and angle. Torque alone tells you how much rotational force was applied; angle tells you how far the screw turned while it was applied. Read together they separate the cases that torque alone confuses. A screw that reaches target torque within a few degrees has probably bottomed out against something hard — possibly a cross-thread. A screw that turns far past the expected angle before reaching torque may be stripping a thread. The pair is what makes under-tightening and over-tightening distinguishable rather than merely flagged.

The second requirement is integrity. A record that the operator can edit is not evidence, so tightening data from our machines is written as tamper-proof entries — the values are captured by the driver and stored without an editing path. That is what a plant quality department needs before a machine goes on the line, and it is routinely what a customer asks for before accepting a supplied component.

The third is the interface, and it is the one to settle earliest. Records can stay on the machine as a local log and be exported on demand, or they can be published to your MES over Ethernet or Wi-Fi so they attach to a unit's record automatically. Which you need is a decision about your quality system rather than about the machine, but it has to be made before the machine is configured — changing it afterwards is a software change, not a rebuild, but it is cheap now and annoying later.

Last updated 2026-11-20. Screw range, torque and cycle-time figures reflect the current published platform specifications.

What to specify

Key points to take away

The practical conclusions from the sections above.

Torque and angle together

The pair distinguishes a bottomed-out screw from a stripping thread; torque alone cannot.

Tamper-proof storage

Records that can be edited are not evidence. Machine-side capture removes the editing path.

Local log or MES

Export on demand, or publish per unit to your MES over Ethernet or Wi-Fi — decide before configuration.

Retention period

Set the retention to match your warranty, homologation or customer requirement, not to the machine's default.

Missed-screw detection

Separate from traceability but usually required together: the machine detects a missed screw and re-tightens automatically.

Common questions

Frequently asked questions

What is the difference between torque monitoring and torque traceability?
Monitoring means the machine checks the joint during tightening and rejects a failure. Traceability means it also stores the values as retrievable evidence. Many machines do the first and not the second.
Can the tightening data be altered after the fact?
Not on our machines — the values are captured at the driver and stored as tamper-proof entries with no editing path. That is the property that makes the record usable as evidence.
Do I need MES integration to get traceability?
No. The machine can hold a local log and export it on demand. MES integration adds automatic attachment to a unit record; whether you need that depends on your quality system.
Keep reading

Related pages

Not sure which applies to you?

Describe the part and the joint and we will tell you which configuration fits — or whether you do not need a machine at all.